Nokia Bluetooth Stereo Headset BH 221 User Manual

Nokia Bluetooth Stereo Headset BH-221  
Issue 2.0  
3
Get started  
Keys and parts  
1
2
3
4
5
6
7
8
Rewind key  
Play/Pause key  
Fast-forward key  
Multifunction key  
Volume up key  
Volume down key  
Micro-USB connector  
Headphones connector  
9
Indicator light  
10 NFC area  
11 FM switch  
12 Microphone  
13 Display  
4
14 Headset  
15 Clip  
Charge the battery  
Before using the headset, you must charge the battery.  
When the battery charge is low, the headset beeps every 5 minutes, and flashes on  
the display. When the battery is charging, the indicator light is on.  
1
2
Plug the charger into a wall outlet.  
Connect the charger cable to the micro-USB connector on the headset. The  
indicator light goes off when the battery is fully charged.  
3
Unplug the charger from the headset, then from the wall outlet.  
When you unplug a charger, hold and pull the plug, not the cord.  
The fully charged battery has power for up to 7 hours of talk time, up to 7 hours of  
music playing time, or up to 150 hours of standby time.  
Check the battery level  
Press . The battery level is shown on the display.  
There is enough power.  
You may need to recharge the battery soon.  
Recharge the battery.  
Switch the headset on  
Press and hold  
for 2 seconds. The headset automatically connects to the last  
connected device. If you've never paired your headset with a device, or you've cleared  
the pairings, pairing mode is switched on.  
5
Switch the headset off  
Press and hold for 2 seconds.  
If the headset is not used or connected to a device within 30 minutes, it switches off.  
Display indicators  
Your headset has a display that gives you all the info you need. Depending on what  
you're doing and your phone model, it shows you the name of the connected device,  
caller name or number, the name of the song you're listening to, and the frequency  
and name (if available) of the radio station.  
General indicators  
You're connected to a device that supports A2DP, such as a music player.  
You're connected to a device that supports HFP, such as a phone.  
The headset has paired or connected successfully.  
The headset is searching for Bluetooth devices.  
Battery indicators  
The battery is full.  
Medium battery level.  
Low battery level.  
The battery is empty.  
Player and FM radio indicators  
You're searching radio stations down through the available frequencies.  
You're searching radio stations up through the available frequencies.  
The player is playing.  
The player is paused.  
The player is rewinding.  
The player is fast-forwarding.  
Call indicators  
You're in a call.  
A call is on hold.  
Someone is calling you.  
You're calling someone.  
Settings and help indicators  
Restore factory settings.  
6
Next setting.  
Previous setting.  
The item is selected.  
The item is not selected.  
Wear the headset  
Connect the headphones to the headphones connector.  
The headset is provided with different-sized rubber earpieces. Select the ones that  
fit you best.  
The earpiece marked L goes in your left ear and the one marked R in your right.  
Gently put the earpieces into your ears, and fit them properly for a good in-ear seal.  
You can clip the headset to your clothing. To see the display better, rotate the clip.  
Pair the device  
Pair and connect the headset  
You can control which devices are allowed to connect to your headset.  
Before using the headset with a compatible device for the first time, you must pair  
and connect them.  
Pair the headset manually for the first time  
1
2
3
4
Make sure the headset is switched off.  
Switch the compatible device on, then switch its Bluetooth on.  
Switch the headset on.  
Set your device to search for Bluetooth devices. For details, see the user guide  
of the device.  
5
6
On your device, select the headset from the list of found devices.  
If asked, type in the passcode 0000.  
If your device doesn't find the headset, make sure pairing mode is switched on.  
Switch pairing mode on  
1
2
Press  
and  
at the same time.  
Press , then select Switch headset discoverable for pairing new devices.  
In some devices, you may need to connect separately after pairing.  
7
Pair and connect the headset using NFC  
With Near Field Communication (NFC), you can pair and connect your headset to your  
compatible device easily. If the device supports NFC, switch its NFC feature on, then  
touch the NFC area of the headset with the NFC area of your device. The headset  
switches on and connects to the device automatically. You can also disconnect the  
headset using NFC. For details on NFC, see the user guide of the device.  
If the device does not support NFC, pair the headset manually.  
Connect the headset to your device  
When you switch your headset on, it automatically connects to the last device it was  
used with. If the headset can't find that device, it tries the next device on its list of  
paired devices.  
If your phone does not support the A2DP profile for listening to music, you can  
separately pair the headset with a music player that supports this profile.  
The paired devices list on your headset can contain up to 8 devices. You can connect  
the headset to 2 compatible devices at the same time: one (usually a phone) that  
supports HFP, and another (usually a music player) that supports A2DP.  
Connect the headset to the last used device manually  
If no other device is connected, press  
to connect to the last used HFP device, or  
to connect to the last used A2DP device. The headset beeps once.  
Switch between devices to change the music source  
If your headset is connected to a device that supports HFP and A2DP, to switch to  
another paired device that supports A2DP, press and hold  
Many phones support both HFP and A2DP.  
.
Make and receive calls  
When making and receiving calls, hold the microphone close to your mouth.  
Make a call  
When the headset is connected to your compatible phone, make a call on it as you  
normally would.  
Answer or end a call  
Press  
Decline a call  
Press twice.  
.
8
You can redial the number you last called, if your phone supports these features with  
the headset.  
Redial the last called number  
When no call is in progress, press  
twice.  
Switch calls between your headset and your phone  
Press and hold for 2 seconds.  
Music  
Play music  
Listen to your favourite music wherever you are.  
You must pair and connect your headset to a phone that supports the A2DP Bluetooth  
profile and has a music player feature, or to a compatible music player that supports  
this profile.  
Warning:  
Continuous exposure to high volume may damage your hearing. Listen to music at a  
moderate level.  
Play a song  
Select the song in the music player, then press  
.
Pause or resume the music  
Press  
.
If you receive or make a call while listening to music, the music is paused.  
Play the next or previous song  
Press  
Start the current song from the beginning  
Press  
Scroll through the current song quickly  
Press and hold or  
once or  
twice.  
.
.
9
Change the volume or boost the bass and treble  
Change the volume  
Use the volume keys.  
If supported, you can also change the volume from the connected device.  
Boost the low or high frequency sounds  
1
Press  
and  
at the same time, then press  
or  
to browse the setting  
options.  
2
Press to select Adjust bass and treble, then select Bass boosting or Treble  
boosting.  
Radio  
Listen to the radio  
Switch the radio on or off  
Use the FM switch.  
Scan for available stations  
Press and hold  
Manually change the frequency  
Press or  
or  
.
.
Settings  
Change the language  
You can select the language to use.  
1
Press  
options.  
and  
at the same time, then press  
or  
to browse the setting  
2
Press to select Change language, then select the language.  
Clear the pairings  
You can clear the paired devices list on your headset.  
Press  
and , then select Restore factory settings. After the settings are cleared,  
pairing mode is switched on.  
10  
Troubleshooting  
Can't connect the headset to a compatible device? Make sure that the headset is  
charged, switched on, and paired with the device.  
Did the headset stop working? Plug the charger into a wall outlet, then connect the  
headset to the charger.  
Product and safety information  
Battery and charger information  
This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as  
you may damage the device.  
This device is intended for use when supplied with power from the following chargers: AC-10. The exact charger model  
number may vary depending on the type of plug. The plug variant is identified by one of the following: E, X, AR, U, A, C, K,  
or B.  
The battery can be charged and discharged hundreds of times, but it will eventually wear out.  
Talk and standby times are estimates only. Actual times are affected by, for example, device settings, features being used,  
battery condition, and temperature.  
If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnect  
and reconnect it.  
If the battery is completely discharged, it may take several minutes before the charging indicator is displayed.  
When your charger is not in use, unplug it from the electrical plug and the device. Do not leave a fully charged battery  
connected to a charger, as overcharging may shorten the battery’s lifetime. If left unused, a fully charged battery will lose  
its charge over time.  
Always keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime  
of the battery. A device with a hot or cold battery may not work temporarily.  
Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Recycle when  
possible. Do not dispose as household waste.  
Use the charger for its intended purpose only. Improper use or use of unapproved chargers may present a risk of fire,  
explosion, or other hazard, and may invalidate any approval or warranty. If you believe the charger is damaged, take it to a  
service centre for inspection before continuing to use it. Never use a damaged charger. Only use the charger indoors.  
Take care of your device  
Handle your device, charger and accessories with care. The following suggestions help you protect your warranty coverage.  
Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode  
electronic circuits. If your device gets wet, allow the device to dry.  
Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged.  
Do not store the device in high temperatures. High temperatures can shorten the life of the device, damage the  
battery, and warp or melt plastics.  
Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form  
inside the device and damage electronic circuits.  
11  
Do not attempt to open the device.  
Unauthorised modifications may damage the device and violate regulations governing radio devices.  
Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and mechanics.  
Only use a soft, clean, dry cloth to clean the surface of the device.  
Do not paint the device. Paint can clog moving parts and prevent proper operation.  
Recycle  
Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way  
you help prevent uncontrolled waste disposal and promote the recycling of materials. Check how to recycle your Nokia  
products at www.nokia.com/recycling.  
Crossed-out wheeled-bin symbol  
The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and  
electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This  
requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more  
environmental information, see the product Eco profile at www.nokia.com/ecoprofile.  
Copyright and other notices  
DECLARATION OF CONFORMITY  
Hereby, NOKIA CORPORATION declares that this BH-221 product is in compliance with the essential requirements and other  
relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/  
© 2011 Nokia. All rights reserved.  
Nokia, Nokia Connecting People, and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia  
Corporation.  
Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior  
written permission of Nokia is prohibited. Nokia operates a policy of continuous development. Nokia reserves the right to  
make changes and improvements to any of the products described in this document without prior notice.  
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Nokia is under license.  
The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either  
express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular  
purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise  
this document or withdraw it at any time without prior notice.  
To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible  
for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.  
12  
The availability of products may vary by region. For more information, contact your Nokia dealer. This device may contain  
commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion  
contrary to law is prohibited.  
/Issue 2.0 EN  

Rockford Fosgate PCH 514 User Manual
Roadmaster Car Component Speaker User Manual
Power Acoustik OVN2 1250 User Manual
Philips GoGear SA6066 User Manual
Pelco Camera Lens 13ZD6X15(P) (CE) User Manual
Panasonic DMR BW500 User Manual
PAC C2R CHYNA User Manual
Nixon Camcorder D1X User Manual
Lastolite TRIFLASH B90023 User Manual
Kenwood Car Stereo System TM 531A User Manual